Research/Deposit model

Manganese deposits

Manganese deposits are beds of manganese oxide and carbonate laid down in shallow seawater at the edge of oxygen-poor basins, many later upgraded by supergene weathering.1,2,3

Ore holds 150 to 500 times the crustal average of about 0.1 percent Mn with iron near its crustal average, so deposits form where iron was removed as pyrite in sulfidic deep water or settled apart from manganese in banded iron formation.1,3

The Kalahari manganese field in South Africa holds more than 70 percent of the world's identified land-based resources of over 17 billion tonnes, at typically about 40 percent Mn.1

Supergene ores, most common in the tropics and on plateaus, include some of the highest grades mined, and Moanda in Gabon is the largest known supergene deposit.1

Volcanogenic, karst and vein manganese deposits are widespread but generally small, and seabed nodules and crusts are a vast resource not yet in commercial production.1

South Africa mined an estimated 7.6 Mt of the world's 20 Mt of contained manganese in 2025, ahead of Gabon at 5 Mt.4

The manganese model

Tectonic setting

  • Stable cratonic interior basins and margins, with ore on shallow shelves around oxygen-poor basins2,3
  • Oceanic ridges, marginal basins, island arcs and young rifts for the smaller volcanogenic deposits1,2

Host rocks

  • Shallow marine (50 to 300 m) carbonate, clay, glauconitic sand and black shale in transgressive sequences, often near black-shale pinchouts2,3
  • Banded iron formation in the Kalahari and at Urucum, and chert, jasper and basalt for volcanogenic deposits1,2

Alteration

  • No alteration mineralogy beyond supergene oxidation, which may raise grade two- to threefold, with typically sharp contacts against primary ore2,3
  • Later hydrothermal enrichment in parts of the Kalahari, and silicification, hematite and greenschist alteration of mafic lavas around volcanogenic deposits1,2

Ore minerals

  • Pyrolusite, cryptomelane, manganite and psilomelane in oxide ore, and braunite in Kalahari and Groote Eylandt ores1,3
  • Rhodochrosite and kutnahorite in carbonate ore, as at Molango and in the Kalahari1,3

Pathfinder elements

  • Mn-enriched beds and the Mn/Fe ratio, which may reflect separation of Mn from Fe by pyrite precipitation3
  • Positive carbon-isotope (δ13C) excursions at some ore horizons, including Groote Eylandt, and Zn, Pb, Cu and Ba that volcanogenic Mn minerals may carry2,3

Geophysical signature

  • Airborne EM may map shallow conductive manganese oxide layers, and has helped define drill targets at some recent mines1
  • Supergene cappings may suit self-potential surveys and hyperspectral mapping may pick out the low reflectance of Mn oxides, while geophysics is generally not effective on primary beds1,3

Grade and tonnage

  • USGS sedimentary Mn model: median 7.3 Mt at 31% Mn, the largest 10% of deposits above 280 Mt and the richest 10% above 49% Mn1,2
  • Kalahari ore typically about 40% Mn, Molango carbonate ore about 28% and Bolshe Tokmak about 18%, and any ore needs at least 15% Mn1

Example deposits

DepositCountryNotes
Kalahari manganese field1,2South Africathree Mn beds in the Hotazel banded iron formation, including the Mamatwan mine
Groote Eylandt1,2,3AustraliaNorthern Territory, Cretaceous pisolitic oxide ore
Molango1,2,3MexicoJurassic rhodochrosite beds, about 9 percent of world resources
Nikopol1,2,3UkraineOligocene marine sedimentary manganese
Moanda1Gabonlargest known supergene manganese deposit

Test your manganese thesis

Agents walk your thesis through the geology, geophysics, drill holes, reports and claims. Overlay host rock, structure, geophysics and open ground to find target areas.

Start a thesis →

Other deposit types

Guides

References

  1. Cannon, W.F., Kimball, B.E., and Corathers, L.A., 2017, Manganese, chap. L of Schulz, K.J., and others, eds., Critical mineral resources of the United States: U.S. Geological Survey Professional Paper 1802-L
  2. Cannon, W.F., and Force, E.R., 1986, Descriptive model of sedimentary Mn (model 34b), Mosier, D.L., 1986, Grade and tonnage model of sedimentary Mn, and Koski, R.A., 1986, Descriptive model of volcanogenic Mn (model 24c), in Cox, D.P., and Singer, D.A., eds., Mineral deposit models: U.S. Geological Survey Bulletin 1693
  3. Force, E.R., Paradis, S., and Simandl, G.J., 1999, Sedimentary manganese (profile F01), in Lefebure, D.V., and Jones, L.D., compilers, 2022, British Columbia Geological Survey mineral deposit profiles, 1995 to 2012: BC Geological Survey GeoFile 2020-11
  4. Kim, J., 2026, Manganese, in Mineral commodity summaries 2026: U.S. Geological Survey