Nickel laterite deposits
Nickel laterites form where deep tropical weathering of peridotite, dunite and serpentinite leaches Mg and silica and leaves Ni and Co concentrated in the residual profile.1,2
Most lie within 26 degrees of the equator, on obducted ophiolites (New Caledonia, Cuba, Dominican Republic) or on komatiites and layered intrusions in stable cratons (Western Australia).1
The three subtypes are oxide (Ni-rich goethite in the limonite), clay (Ni smectite in the transition zone) and hydrous Mg-silicate (garnierite and related minerals in the saprolite).1
Deposits run 2.5 to about 400 Mt at 0.66 to 2.4 percent Ni (median 1.3) and 0.01 to 0.15 percent Co (median 0.08), most with ore in more than one horizon.1
Laterites hold most of the world's nickel resources.1
The nickel laterite model
Tectonic setting
- Obducted ophiolite sheets on active margins and accreted terranes, uplifted to expose ultramafic rock1,2
- Komatiites and layered mafic-ultramafic intrusions in stable cratons, parent to about 15 percent of known deposits1
Host rocks
- Dunite, harzburgite, peridotite and serpentinized peridotite, parent to about 85 percent of known deposits1,2
- Fresh ultramafic rock carries up to about 0.3 percent Ni1
Alteration
- Profile from the top: ferricrete cap, limonite, a smectite transition zone only where drainage is very poor, saprolite, then fresh protolith1
- Red-brown pisolitic soils, and chalcedony and garnierite boxwork near the weathering front2
Ore minerals
- Nickel-rich goethite in the limonite, and garnierite and other hydrous Mg-Ni silicates in the saprolite1,2
- Nickel smectites such as nontronite, and Mn oxides (asbolane, lithiophorite, heterogenite) that carry cobalt1
Pathfinder elements
- Ni, Co and Cr enriched and MgO below 40 percent, lower than in fresh peridotite2
- Fe, Cr, Al, Ti, Zr and Cu residually concentrated, Ni, Mn, Co, Zn and Y secondarily enriched, and Mg, Ca and silica leached1
Geophysical signature
- Magnetic highs over thick ultramafic sections, but in northeastern Cuba known deposits sit on magnetic lows over thin serpentinized bodies1
- Low K, U and Th radiometric response over ultramafic rock, and EM, resistivity and ground-penetrating radar can map the weathering profile1
Grade and tonnage
- Limonite 0.5 to 2 percent Ni in iron oxides, and saprolite and boxwork typically 2 to 4 percent Ni in hydrous silicates2
- Murrin Murrin resource 268 Mt at 1.01 percent Ni and 0.074 percent Co, and Moa Bay measured and indicated 66.6 Mt at 1.26 percent Ni and 0.13 percent Co1
Example deposits
| Deposit | Country | Notes |
|---|---|---|
| Moa Bay1 | Cuba | oxide ore |
| Murrin Murrin1,3 | Australia | Western Australia, clay ore |
| Falcondo1 | Dominican Republic | hydrous Mg-silicate ore |
| Goro1 | New Caledonia | limonite and saprolite ore |
| Cerro Matoso1,2 | Colombia | lateritic Ni |
Test your nickel laterite thesis
Agents walk your thesis through the geology, geophysics, drill holes, reports and claims. Overlay host rock, structure, geophysics and open ground to find target areas.
Other deposit types
Guides
References
- Marsh, E., Anderson, E., and Gray, F., 2013, Nickel-cobalt laterites, a deposit model, chap. H of Mineral deposit models for resource assessment: U.S. Geological Survey Scientific Investigations Report 2010-5070-H
- Singer, D.A., 1986, Descriptive model of lateritic Ni and grade and tonnage model of lateritic Ni (model 38a), in Cox, D.P., and Singer, D.A., eds., Mineral deposit models: U.S. Geological Survey Bulletin 1693
- Hofstra, A., Lisitsin, V., Corriveau, L., Paradis, S., Peter, J., and others, 2021, Deposit classification scheme for the Critical Minerals Mapping Initiative Global Geochemical Database: U.S. Geological Survey Open-File Report 2021-1049, Table 2 (laterite nickel row)