Research/Deposit model

Potash deposits

Potash deposits are beds of sylvite, carnallite and other potassium salts with halite in thick marine evaporite sequences, plus potassium-rich brines in closed continental basins.1,2

They are attributed to evaporation of seawater to the bittern stage in restricted basins under hot, hyperarid climates, and halite usually more than 100 m thick is thought necessary before potash forms.2

About 75 percent of world production comes from flat-lying stratabound salt, more than a quarter of that from the Middle Devonian Prairie Evaporite of Saskatchewan, and 10 to 15 percent from salt domes and other halokinetic structures.2

Salt flow can thin, thicken, repeat or wipe out potash beds, but it can also bring them to shallower depths where they are easier to mine, and groundwater on rising salt structures may leach carnallite to sylvite.1,2

Most brine deposits are young, near-surface brines in continental closed basins such as playas and salars, worked at the Dead Sea, the Salar de Atacama and the Qaidam basin.1

Canada mined about 15 Mt K2O of the world's 49 Mt in 2025, and Russia, Canada and Laos report the largest quantified reserves.3

The potash model

Tectonic setting

  • Restricted basins, likely between 15 and 45° north or south of the equator, under hot, hyperarid climate in rift, foreland, intracontinental sag and transform settings2
  • Intracratonic basins hold most potash, while rift basins give thicker, elongate salt that tends to form salt structures1

Host rocks

  • Rock salt, sylvinite, carnallitite, kainitite, hartsalz, anhydrite and gypsum in halite-dominated evaporite sequences2
  • Potash beds under 1 m to several tens of metres thick at the top of cycles of red beds, carbonate, anhydrite or gypsum, and halite2

Alteration

  • Groundwater and less saline brine dissolve and recrystallize potash salt and can remove a deposit entirely2
  • In rising salt structures, surface and groundwater may leach carnallite to sylvite, and dissolution leaves a caprock of gypsum, anhydrite and clay that may be tens to a thousand metres thick2

Ore minerals

  • Sylvite (KCl), carnallite (KMgCl3·6H2O), kainite, polyhalite and langbeinite, intergrown with halite2
  • The dominant ore assemblages are sylvite and halite with under 6 weight percent carnallite, or carnallite and halite with negligible sylvite2

Pathfinder elements

  • K, Na, Mg, Br, Cl and sulfate in borehole brines and groundwater, and exceptionally saline wells and springs, which have led to discoveries of concealed potash2
  • Bromine in halite, rising through unaltered evaporite cycles as the brine nears the potash stage2

Geophysical signature

  • Gamma-ray logs read potassium in drill holes from natural K-402
  • Reflection seismic maps salt beds and structures, and gravity surveys outline salt structures because salt is less dense than most enclosing sediment2

Grade and tonnage

  • Stratabound deposits: explored averages of 5.3 to 38% K2O, most operating mines 11 to 25% K2O, and the lowest mined average 8 to 10% K2O at cutoffs below 4%2
  • Reported deposit tonnages run from a few tens of millions to 30 billion tonnes, and most mined salt-structure deposits hold 50 Mt to several hundred Mt at grades that commonly average under 20% K2O2

Example deposits

DepositCountryNotes
Elk Point Basin1,2CanadaSaskatchewan, stratabound potash in the Middle Devonian Prairie Evaporite Formation
Solikamsk Basin (Berezniki and Solikamsk mines)1,2Russiaupper Permian stratabound potash
Pripyat Basin1,2BelarusUpper Devonian stratabound potash
Zechstein Basin1,2Germanyupper Permian potash in both stratabound beds and salt structures
Dead Sea1,3Israel and Jordanpotash recovered from brine

Test your potash thesis

Agents walk your thesis through the geology, geophysics, drill holes, reports and claims. Overlay host rock, structure, geophysics and open ground to find target areas.

Start a thesis →

Other deposit types

Guides

References

  1. Orris, G.J., Cocker, M.D., Dunlap, P., Wynn, J., Spanski, G.T., Briggs, D.A., and Gass, L., 2014, Potash: a global overview of evaporite-related potash resources, including spatial databases of deposits, occurrences, and permissive tracts: U.S. Geological Survey Scientific Investigations Report 2010-5090-S, chapters 1 to 3
  2. Cocker, M.D., and Orris, G.J., 2014, Summary descriptive models of stratabound and halokinetic potash-bearing salt deposits, appendixes A and B in Orris, G.J., and others, Potash: a global overview of evaporite-related potash resources: U.S. Geological Survey Scientific Investigations Report 2010-5090-S
  3. Jasinski, S.M., 2026, Potash, in Mineral commodity summaries 2026: U.S. Geological Survey